Feed Forward Control Loops
-A feedback control loop is reactive in nature and represents a response to the effect of a load change or upset. A feedforward control loop, on the other hand, responds directly to load changes and thus provides improved control.
-In feedforward control, a sensor is used to detect process load changes or disturbances as they enter the system. A block diagram of a typical feed- forward control loop is shown in the following Figure. Sensors measure the values of the load variables, and a computer calculates the correct control signal for the existing load conditions and process set point.
-Feedforward control poses some significant problems. Its configuration assumes that the disturbances are known in advance, that they will have sensors associated with them, and that no important undetected disturbances will occur.
-Therefore, feedforward control is more complicated and more expensive, and it requires the operator to have a better understanding of the process than does a standard feedback control loop. So, feedforward control is generally reserved for well-understood and critical applications.
A nice idea to create a blog with such themes.
ReplyDeleteGud luck!
We have found your discussion a good start to a critical problem in a small country.
ReplyDeleteWe are hoping to establish a system to pre-engage an electrical system before critical load is reached with the use of fuzzy logic control.